Jamz

It just pulls out... its all held in with clips Easyest way is to start pulling from above the steering wheel

had a look in mine and nothing! Dont think it could get past the engines which have covers on.

Just tried to wire them in now, but didnt work :( For some reason the lights dont work, took them appart to see if there is any fuse in it, but couldnt find any, then thought i might have blown one of the caps, but didnt see any scorch markes or anything.... Totally puzzled

We used to like

This should help http://www.focuscanada.net/forum/index. ... topic=8122

I was going to do the big 3 on mine, but not had chance to do it

I dont have a problem with the arm reast / handbrake :lol:

Will have to have a look at mine.... bit of a pain to get to my spark plugs though, as my engine has an individual coil pack bolted onto the top of the engine

oh and you know where you say "Central Junction Box" Where is that?

So dave, you have the oil temp and pressure working.... was that using the wiring which was in the car, or have you used new sesors?

Its fine for 2 cans, but as soon as you visit McDonalds or anywhere like that, you can fit one in and use your lass for the other one! Just found today the good cup holders on the rear arm rest... might have to start using them!

Tis the same as the fiesta ones mate.... not got mine working, but did have a look for the so called relay plug, but all i found was the airbag sensor

Good thinking.... BTW darando, did you get my PM

I did put a post up, but no reply :(

Note the mk1 ST dont have a turbo, but has the oil temp and oil pressure ;)

Nope, but you can get the oil pressure and oil temp part working! Will change the turbo bit to something like the air to fuel ratio... or there is a canny little supercharger im looking at ;)

Right, im trying to get this wired up, and get at least the illumination to work... Ive tried the wires myself and couldnt find which wires were the illumination, but i did get the pins in the pod to move Here are the wires in the unit:

What engine do you have craig?

Very Nice!

The replica ones look nothing like the ST one's anyway

You could go around and tighten all the bolts back up, and yes you do need the heat sheild, it stops things from melting

Real ones: These ones are Daves http://cgi.ebay.co.uk/Ford-Focus-ST-Whe ... dZViewItem

So is it pretty much plug and play?

The heat shield is from the front of the car all the way to the back, where the exhaust goes. Nothing much you can do to stop it

Will be the heat shield